DoMyOwnPestControl had the best price on the Internet that I could find for these Victor wooden rat traps. And as the advertising at the top of their web page says, “Fast, Free shipping”. Fantastic! A big plus to me. Thought these wooden Victor’s were lost to me forever. Not so – thanks to your great service.
Another live capture cage trap uses a wire funnel that allows only one way movement into the device. Rats can squeeze themselves forward through openings as small as a quarter but cannot exit due exposed wires at the end of the funnel. The sharp ends poke the rodents in the face and body if they make the attempt.
Once you catch a rat in a live trap you will need to figure out what you want to do with it. Some states have laws that require you to kill any trapped nuisance rodents. If you do decide to release the rat then do so as far away from your home (and those of others) as practical.
Seal off wherever the rodents are entering your home. One of the most important and effective ways of controlling unwanted rodents is blocking off their entrance point. This will prevent more rodents from getting into your home.
I came out the next morning before work and both traps had been sprung. The trap set along the fence – nada. The trap in the garden – success! I disposed of the rat and re-baited and re-set the traps because I suspect where there’s one rat, there’s many. So, with the Victor M326 Professional Rat Trap as my weapon of choice the Great Garden Rat War of 2013 will rage on … and any remaining rat’s days are numbered.
The Victor Electronic Rat Trap is easy-to-use. Start by inserting four ‘C’ batteries into the battery compartment and replacing the cover. Then, using a Q-tip or toothpick (to avoid leaving your scent), add an enticing rat snack like peanut butter or dry pet food through the hole in the back wall of the trap. Place the rat trap where there are signs of rodent activity. Since rats typically travel along the edge of a room, the trap can also be placed lengthwise along the wall with the bait side closest to the wall. Flip the switch to ‘on’, and it’s good to go—a green light will blink once and a short buzzing sound will be heard to verify it’s working.
For the best results, we recommend placing the trap along the wall where rodents primarily travel. The bait and trigger end of the mouse trap should be flush against the wall so that mice will be tempted to explore them. We recommend baiting the trap with a toothpick amount of peanut butter. Anything more than that, and the mice may be able to access the bait without setting off the trap.
A: The Victor® Metal Pedal Mouse Trap can be reused or disposed of. It is personal preference. Check the traps frequently to ensure the trap is emptied as soon as the mouse is captured and the traps will last longer. Please note that for personal hygiene and biohazard awareness, disposable gloves should always be worn when installing or recovering any traps.
Thanks Stephanie. I was thinking of buying one of these sonic devices to keep snakes away (I have a small cat and live with very large pythons outside) If it’s going to disturb the cat and the dog, then I can’t
Decided to try some traps, guess what !? Spent another $60 for 2 traps in vain. No rats were caught in almost a month, nevertheless rats became less and less shy, sometimes appearing in broad daylight.
We recommend using either glue boards or snap traps( indoors to get rid of rodents. It is important to use the appropriate size trap as a mouse trap is not strong enough to trap a rat and a rat trap is not sensitive enough to trap a mouse. Using baits indoors can lead to a dead rat/mouse in an inaccessible area that causes odor and secondary insect infestations. Read the following articles for great tips on indoor rodent control:
Fulfillment by Amazon (FBA) is a service we offer sellers that lets them store their products in Amazon’s fulfillment centers, and we directly pack, ship, and provide customer service for these products. Something we hope you’ll especially enjoy: FBA items qualify for FREE Shipping and Amazon Prime.
Insert skewers into the bottle. Take two five-inch wooden skewers of the kind used to grill shish kebab or construct various arts and crafts projects. They should be only a millimeter or so in diameter. Press the two skewers through the bottle from one set of points to the other using the marks you made.
Place the tube on the edge of a countertop or second story landing. Place the tube in such a way so that about 40% of it, including the baited end, hangs over the edge of the landing. If necessary, affix the tube with a small piece of tape, but take care not to tape it so firmly that it would not give way and tip over the edge of the landing or countertop when the baited end was subjected to slight force.
Best of all, glue traps do not use harmful chemicals or poisons to eliminate the rodent problem in your home. Victor® rat glue traps consist of a non-toxic glue to offer a superior hold. For peace of mind, this glue can be safely used anywhere around your home or business – even around food, water, children and pets!
On the end of the planks that hang over the buckets, smear a bit of peanut butter to attract rats. Attach longer boards on the other end of the boxes for the rats to crawl up. Rodents are nice climbers and can get to a food source in any place.
When rats take up residence under the kitchen sink, a rat trap is often required to evict the pesky visitors. Snap traps are thought of as the more humane lethal rat trap, killing rats quickly. Snap traps also dont pose the health risks affiliated with rat poisons.
So as you can see here, you take an empty toilet paper roll and crease one side so it fits flat along the edge of a table or counter top. Balancing may be difficult at first, but that’s the concept to making this work. Once you find that sweet spot, place some peanut butter or some cracker crumbs at the end of the tube. The key is to making sure you have a tall enough bucket or bin below to where the mouse will fall as it reaches the end of the tube. Simple, cheap, and efficient. My kind of mouse trap.
more information about
I have battled rats for many years. Living close to a creek with sewer lines that run along it, these pesky critters always show up in the basement every winter. I’ve used just about every snap rat trap on the market, and although alot of the other traps work, these traps are the ones I keep coming back to. These traps work and work very well.
Mouse traps can be a little bit expensive, especially if you have a serious mouse problem. Fortunately, it’s easy to make cheap, effective mousetraps with everyday items. The crafty homeowner can turn cardboard rolls, plastic bottles, and coffee cans into homemade mousetraps.
I’ve purchased recently Ultrasonic pest repeller from amazon “http://amzn.com/B017IEZIVQ” i am really happy with it, I have a detached garage and we put everything in there as our storage room. I have a contract with pest control monthly and no matter what they do mice still coming back because we stored some dry foods in there like dog foods,dry cereals and etc.I’ve tried everything to get rid of them but they only stop for days and then coming back again. So i knew i need to do something else permanent to get rid of them and this Best Indoor Electronic Plug in Pest Control is doing a great job it does what is supposed to do. We used to have alots of crickets, waterbugs and spider too but now since i plug this pest repeller in my garage i have never seen any sign of them anymore no more mice and no more bugs and insects inside my garage. This repeller has been working really good and im so happy with it.
The Better Gluetrap Cold Temperature offers a special The Better Gluetrap Cold Temperature offers a special formulated glue that keeps capturing unwanted intruders in temperatures as low as 0°. These instant catch on contact traps are the simple cost-effective and non-toxic option for controlling mice rats snakes and other crawling pests. The heavy-duty low-profile designed trap comes pre-baited … More + Product Details Close
Once crimped, insert the wire into both holes. You will need to bend the second side of the wire to get it in the hole. Just straighten the wire after it’s through the hole. Center the can over the bucket opening and bend the spare wire on the outside of the bucket around the bucket rim to keep the can centered over the bucket.